Triductor EtherCAT Slave Chips
An EtherCAT slave controller (ESC) is a chip dedicated to EtherCAT communication. The microcontroller only exchanges data with it over SPI or a parallel bus. TIWON supplies Triductor (创耀科技) ESCs and provides technical support for circuit design.
Chip Photos
The chips we supply, photographed at the same scale. The large marks on the ruler above are 1 cm apart.




Chip Comparison
| Item | TR8211 / TR8211K | TR8251EC | TR8253EC | TR8253LC | TR8254EC |
|---|---|---|---|---|---|
| EtherCAT ports | 2~3 | 2 | 2~4 | 2~3 | 2~4 |
| Built-in PHY | None (external MII) | 2 | 2 | 2 | 2 |
| PDI | HBI, SPI | SPI, SQI | SPI, SQI, HBI | SPI, SQI, HBI | SPI, SQI, HBI |
| Built-in EEPROM | None | 64 kbit | 64 kbit | None | 64 kbit |
| Digital I/O | 16/32 bit | None | 16 bit | 16 bit | 32 bit |
| Fiber (FX) | — | Not supported | Not supported | Not supported | Supported |
| Package | QFP100 / TFBGA128 | QFN40 5×5 | QFN64 9×9 | QFN64 9×9 | QFN80 9×9 |
| Operating temperature | -40~85 ℃ | -40~105 ℃ | -40~105 ℃ | -40~105 ℃ | -40~105 ℃ |
| Typical use | ET1100 replacement (without E-bus) | Micro servos, joint modules | Cascade junctions | LAN9252/9253 replacement | 4-way branching, fiber, 32 DIO |
Sources: the datasheet of each chip (TR8211 r1.03, TR8251EC r1.02, TR8253EC/LC r1.01, TR8254EC r1.02) and the Triductor product introduction.
Which Chip to Choose
- Small, low-power joint modules and micro servos — TR8251EC (QFN40 5×5 mm, SPI and SQI only)
- Replacing an existing ET1100 design — TR8211K (pin-compatible when EBUS is not used, with 3 ports or fewer and 3.3 V I/O)
- Replacing an existing LAN9252/9253 QFN design — TR8253LC
- Devices that branch in several directions — TR8254EC (4 ports) or TR8253EC (cascade)
- Fiber connection — only TR8254EC supports fiber (FX)
Download the selection guides
- Triductor EtherCAT Chip OverviewOverview of the six-chip family and a selection guide by applicationPDF · 10 pages · Korean · 2.3 MBDownload
- From LAN9252 to TR8253LC — pin-compatible replacement reviewWhat to check when replacing a Microchip LAN9252 design with TR8253LCPDF · 10 pages · Korean · 2.1 MBDownload
- From ET1100 to TR8211K — pin-compatible replacement reviewWhat to check when replacing a Beckhoff ET1100 design with TR8211KPDF · 10 pages · Korean · 2.1 MBDownload
TIWON Evaluation Boards

TR8253LC EtherCAT ShieldEtherCAT slave evaluation board in the Arduino UNO form factor2 built-in PHYs · SPI · 4 layers

TR8251EC EtherCAT ShieldArduino UNO form-factor evaluation board with an ultra-small ESCQFN40 5×5 mm · built-in EEPROM
Drawing in preparation
TR8211K HBI DaughterboardParallel-bus EtherCAT evaluation board for NUCLEO-U575ZI-QHBI 16-bit → direct to STM32 FMC
Are you developing an EtherCAT device?
We work through it with you, from chip selection and circuit design to slave firmware.